Cairo’s Top-Rated Disinfecting and Sanitizing Services | HLPR

Meanwhile, with the spread of the Coronavirus, it is not enough to clean surfaces with soap and water to keep the place clean, healthy and safe, so it is indispensable for continuous disinfection of workplaces and companies to preserve the health of employees and customers from viruses and micro germs.

At HLPR, we provide professional disinfection and sterilization services for companies and workplaces using safe chemicals, as sterilization is a process that reduces and kills germs to make surfaces safe for contact.

The sterilization service will provide you with the necessary disinfection to work with confidence from the spread of any viruses, and all our specialists receive practical training regarding the correct and safe method of sterilization and disinfection according to international standards.

And if you have questions about the sterilization process, here are our steps to complete this process:

We use Virkon S, which independent tests have shown that it disrupts a closely related alternative to the currently circulating strain of coronavirus.

In independent tests, Virkon achieved inactivation of the coronavirus strain at a 1:100 dilution ratio with a contact time of 10 minutes, which complies with US Environmental Protection Agency (EPA) testing requirements and demonstrates Virkon S performance and suitability for practical use.

Also, a 1:100 (1%) dilution during use has been shown to be non-irritating to the skin and eyes and does not cause harm to the user, and this chemical is safe to use around children and pets, so it is safe for the skin as well as environmentally friendly.

1- Preparation and personal protective equipment:

All assistants wear their own personal protective equipment and wipe the surfaces to remove any dust particles attached to them. Virkon S solution is prepared at a 1% dilution.

2- Virkon S spray:

Buildings will be sprayed with Virkon S and focus on high-risk areas (door handles, desks, chairs) at an application rate of 300 ml/m.

3- Wait 10 minutes:

Virkon S solution will be left on the surface for 10 minutes to be effective.

4- Scan:

Then all disinfected surfaces will be cleaned by wiping it again.